Safety precautions for fautomatic construction mesh welding machine:
1. Operators within the range of motion of the pulling net platform should pay attention to safety.
2. Wear glasses when welding the mesh to prevent sparks from splashing in.
3. Be sure to cut off the power supply if it is not used for a long time, and the pulling net platform should return to the starting position before cutting off the power supply.
Operating procedures for automatic construction mesh welding machine:
1. Before operation, the automatic construction mesh welding machine must be used and managed by a special person. The operator must be proficient in its structure, performance, operation and maintenance, and can only operate on the machine after training; check the automatic construction mesh welding machine, whether the fasteners are loose, whether the sprocket, gear frame, gearbox and MOV are loose. The NG track is short of oil; check whether the switch of the electronic control box is sensitive, safe and reliable, and whether there is any abnormality; whether the metal casing of the electrical equipment has firm and reliable zero (ground) protection.

2. During operation: turn on the power switch to supply power to the automatic construction mesh welding machine; check whether the traction network platform is in the starting position, if it is in the third step, if not adjust the traction network platform to the starting position, at the same time the traction network controller It must be adjusted to the HP position and confirmed; put "W" to put the "net pulling control switch" and "net pulling control switch" in the closed position, put in the diameter line, press the "start" button. Start the spindle motor, open the "regulator " switch, rotate the "regulator" button to make the machine rotate; rotate the first weft yarn downward, and then turn on the "net pulling control" switch, the mesh welding machine will automatically weld; pay attention to install the weft yarn into the weft yarn placement device in time.,
3. After the welding of the automatic construction mesh welding machine is completed, turn off the "welding mesh control" and "pulling mesh control" switches, turn the speed control button to the "off" position, press the brake, and the mesh welding machine stops working; take out the mesh Sheet, penetrate the diameter line of the next mesh welding machine; press the "return" button, the mesh platform returns to the starting position. Repeat steps. Work normally.