The working principle of China wire straightening and cutting machine:
The motor speeds up through the belt drive, so that the straightening cylinder rotates at a high speed, and the steel bars passing through the straightening cylinder are straightened, and the scale on the surface of the steel bar is removed by the straightening die; the motor is driven by another pair of reduction belts and a gear reduction box, On the one hand, it drives two conveying pressure rollers to pull the steel bar forward, and on the other hand, it drives the crank wheel to make the hammer head move up and down. When the steel bar is adjusted to the predetermined length, the hammer hits the upper knife rest to cut the steel bar, and when the cut steel bar falls into the receiving rack, the knife table returns to its original position due to the action of the spring, completing a cycle.
The correct operating procedures for China wire straightening and cutting machine:
1) Conscientiously implement the relevant provisions of the "General Operating Procedures for Forging Equipment".
2) China wire straightening and cutting machine must do the following carefully during operation:
(1) When the head of the steel is bent and cannot be fed in, stop the machine immediately and take it out, and do not allow it to pass through.
(2) When it is found that the steel is fed in a spiral shape, stop the machine immediately and take it out, and do not let it pass.
(3) If the steel material to be straightened is a coil, you should always pay attention to the working condition of the coil rack, and stop the machine immediately if you find any confusion. When the processing of the coil is almost finished, the tail of the material should be removed from the rack.
(4) Remember to turn off the switch and cut off the power after China wire straightening and cutting machine is finished.