What should I pay attention to when operating the wire straightening and cutting machine?
- Classification:Wire straightening and cutting machine
- Author:
- Source:
- Published:2021-07-30
- 访问量:0
[Description]This article introduces the problems needing attention when operating the wire straightening and cutting machine
What should I pay attention to when operating the wire straightening and cutting machine?
[Description]This article introduces the problems needing attention when operating the wire straightening and cutting machine
- Classification:Wire straightening and cutting machine
- Author:
- Source:
- Published:2021-07-30
- 访问量:0
1. Before starting the machine, check whether the hydraulic oil of the hydraulic station of the wire straightening and cutting machine and the gear oil of the reduction gearbox and transmission gearbox are full. Check whether there are obstacles on the working face and guide rail. If there are obstacles, they must be removed
2. Before starting the main motor, check and adjust the angle of the wire straightening and cutting machine and adjust the working pressure of the hydraulic system.
3. Inject lubricating oil into each lubricating point and check the operation of the mechanical transmission part to make it transport and install flexibly.
4. Operators shall wear labor protection articles and shall not leave or leave their posts after startup.
5. After the oil temperature and oil pressure of the hydraulic station are stable, the upper straightening roll is lifted to the initial position.
6. When the steel pipe is manually put into operation, the steel pipe is sent to the third pair of straightening rollers of wire straightening and cutting machine, and then the upper straightening roller is pressed down and clamped.
7. Start the main motor, the steel pipe rotates forward and is straightened at the same time. If cutting is required, it shall be sent to the cutting section for processing after each straightening. After cutting, the cutting torch shall be lifted to the highest place to avoid hitting the steel plate and damaging the cutting torch
8. When the motor stops, the straightening roller of the wire straightening and cutting machine stops straightening, the upper straightening roller lifts and sends out the straightened and cut steel pipe.
9. The main motor stops, the straightening roller stops straightening, and the steel pipe is sent to the end point, waiting for the next program instruction.
10. After shutdown, turn off the main power supply of wire straightening and cutting machine, and do not change the program controller at will.
扫二维码用手机看
CONTACT US
ADD: Taicheng industry Zone, Anping County, Hengshui City, Hebei Province,China
TEL: 0086-13780280569
EMAIL: dxexport@yeah.net
- Follow us -
Copyright © 2020 Anping Dixun wire mesh products co.,ltd