What are the components of the wire straightening and cutting machine? Let's take a look at it together!
1. Cut off the part
This part of the main motor drives the hydraulic pump station through electromagnetic commutation and overflow valve control. The reciprocating stroke of the movable upper knife assembled on the cylinder piston rod of the parallel track movable trolley and the fixed round bottom knife assembled on the cylinder seat are frustrated. Thus, the wire passing through the round-bottomed knife is cut. Since the wire is cut during operation, the momentary resistance during cutting pushes the movable trolley forward to form a knife movement. When the piston rod drives the upper knife back, the supply wire eliminates the resistance, which When the mobile trolley is pulled back to position by the steel wire under the action of the heavy mound, it is in a waiting state. The main gear pump, electromagnetic reversing valve, overflow valve, accumulation block, mobile trolley, balance rail, high-pressure oil pipe, oil pool, etc. 

2. Straighten the host part
It adopts multi-wheel feeding and straightening, compact structure, good overall performance, and high production accuracy. The transmission part adopts closed oil bath lubrication, which can greatly reduce the wear of mechanical parts and improve work efficiency; multiple sets of straightening wheels act on the wire rod The straightening effect is good at different points; the movement direction of the wire is exactly the same as the movement direction of the straightening wheel, there is no relative friction, and the rib is avoided; the frequency conversion speed control device is adopted, and the speed adjustment range is wide, which effectively saves electric energy and is convenient to operate.
The above is a brief introduction to the knowledge of part of the wire straightening and cutting machine.